PACK 36

 Return to the BUILD


“After creating the interior and engine section, we now focus on the replica model DB5’s body, first looking at the car’s front and its doors.”

 

Contents


Parts

This image includes the parts for the entire issue. However, the parts included with this pack are:

  • Bonnet Hinge
  • Support Rod Holder

Materials: The Bonnet Hinge is metal, but the Support Rod Holder is plastic.

Screws

This pack came with one bag of unlabeled screws containing the following type(s):

  • Two (2) Type I (silver) – These are a NEW type of screw, with the thicker 2.3mm shaft
  • One (1) Type K (silver) – This is a NEW type of screw, with the thinner 2.0mm shaft

NOTE: Neither of these screws are shown on the parts page of the magazine, nor are they listed on the Screws inventory.

Build


Bonnet Hinge

Retrieve the Bonnet (Hood) we received with Pack 03. Fit the Bonnet Hinge to the front edge of the Bonnet as shown, aligning the two holes:

Secure the Bonnet Hinge to the Bonnet with two (2) Type I (silver) screws.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Support Rod Holder

Fit the Support Rod Holder to the rear edge of the Bonnet as shown, and secure with one (1) Type K (silver) screw:

Thoughts


After spending so much time working on the last pack, this one went by fast! It is weird that the screws supplied in this pack are not mentioned anywhere, but they fit just fine. I’m guessing they changed the build yet again since printing the magazines.

Next Up


Pack 37 – Support Rod, Radiator Front, Radiator Rear, Water Tank Part

4 thoughts on “PACK 36”

    1. I am in the UK and i also did not receive the i or k screws in pack 36. I have the 2010 original version of the kit. Are you in the US with a current subscription or was your kit from 2010? The screws are not listed on the early version of the screw chart. You can use the spare silver screws from issues 41, 45 & 56 to complete pack 36. It might be an error that has since been corrected in the current US subscription.

      1. I am in the US, but I think the parts for my build came from both an old and new release as some had red package cardboard and some had black. Thanks for the info on the additional screws!

  1. I am in the US and also did not receive those screws. I improvised and used some found screws and super glue. Didn’t want to wait.

Leave a Reply

Your email address will not be published. Required fields are marked *