PACK 37

 Return to the BUILD


“The parts supplied with this issue help to build up the front section, with the bonnet’s support rod – or bracing rod – and the radiator section. They will all be concealed inside the model.”

 

Contents


Parts

This image includes the parts for the entire issue. However, the parts included with this pack are:

  • Support Rod
  • Radiator Front
  • Radiator Rear
  • Water Tank Part

Materials: The Support Rod is metal, but the rest of these parts are plastic.

Screws

This pack came with one bag of unlabeled screws containing the following type(s):

  • Three (3) Type R – These are a NEW type of screw

Build


Support Rod

Retrieve the Bonnet (Hood) assembly from the previous pack. Fit the center of the Support Rod into this slot of the Support Rod Holder

… and the ends of the Support Rod into these small grooves of the Bonnet.

You may find it easier to stick the ends of the Support Rod into the Bonnet grooves first, then slide the center of the rod into the Support Rod Holder:

Once complete, it should look like this:

Radiator Front and Rear

Align the four posts of the Radiator Rear to the matching holes of the Radiator Front and squeeze the parts together:

When these are assembled, they should be flush to each other:

Thoughts


This was another short pack. We did not use the Water Tank Part in this pack and it is one of the very last things we will install on the model. Keep all of these parts safely stored for now.

Next Up


Pack 38 – Front Bumper Base/Part, Left Door Arm Rest/Inside Handle

Leave a Reply

Your email address will not be published. Required fields are marked *